Skip to content
KitProbe

Speaker test (left and right)

Play sounds on the left and right speakers separately to find dead, crackling or rattling speakers.

Before you start

  • Set the volume to about half.
  • Unplug any headphones.

Listen for rattling or buzzing as the tone rises.

How did it go?

Saved on this laptop for one hour, so the run-all-tests page can collect it. Tap your answer again to clear it.

Next test: Battery health

How to use it

  1. Set the volume to about half.
  2. Press Left, then Right. Each sound should come only from that side.
  3. Press Low-to-high sweep and listen as the tone rises.

What a problem looks like

  • No sound from one side: that speaker is dead or disconnected.
  • Sound from the wrong side: left and right are swapped in the system settings. This is rarely a hardware fault.
  • Rattling or buzzing at some point in the sweep: a damaged speaker or a loose part inside the case.

Buying used

  • Test once at half volume and once near maximum. Some damage only shows when it's loud.
  • If the laptop has a headphone jack, plug in headphones and test again.

FAQ

Can I test headphones with it?

Yes. Plug them in and run the same left, right and sweep tests. A side that stays silent points to the headphones, the cable or the jack.

Is the sweep safe for the speakers?

At half volume, yes. Turn it up only for a short second pass to listen for rattles.

The test is fine but videos sound wrong. Why?

Check the sound settings: a mono-audio or balance option, or an audio enhancement, can change how videos sound without any hardware fault.